How to Reset ESP BAS Light? (5 Easy Steps To Follow)

The ESP BAS light is one of many warning lights and indicators that usually turns on when something is wrong with your vehicle. They are usually located on your car’s dashboard.

An ESP BAS light is usually turned on when your vehicle is experiencing problems with either your electronic stability program or your vehicle’s brake assist program.


How to Reset ESP BAS Light? (Step By Step Guide)

You can easily reset your vehicle’s ESP BAS light by following the detailed and easy-to-remember step-by-step guide given below.

Step 1 – First you need to start your car’s engine and then turn your car’s steering wheel all the way to the right until it comes to a stop.

Step 2 – Secondly you need to turn the steering wheel all the way to the left until it again comes to a stop.

Step 3 – During the third step you need to bring the steering wheel back towards the right until the wheels are all centered.

Step 4 – Now you will see the light has turned off.

Step 5 – Finally, if you still notice that the ESP BAS light is still on that means it needs to be replaced as it is faulty or there could be something faulty with the sensor, and a technical diagnosis by the professionals is needed.

Should You Drive With an ESP BAS Light On?

You should definitely not drive when your ESP BAS light is on. This is because the ESP BAS light is a warning light that indicates your car is experiencing problems and is not safe to drive. This can occur due to many reasons.

Some such reasons can be that your car is facing a steering wheel problem or problems with a bad wheel speed sensor and faulty brake switch or worn-out brake pads.

The problems can only be solved through professional help.

What causes ESP BAS light to Come On?

There is 4 main reasons as to what causes ESP BAS light to turn on. Those 4 reasons are explained in detail below.

Faulty Brake Switch

The brake switch in your car’s braking system turns on the brake lights that lets others driving behind you know that you have pressed on brakes. This brake switch can easily go bad, causing to turn on your ESP BAS light.

Faulty Brake Pads

Faulty brake pads usually causes to alter the rate at which your vehicle’s wheels spin and this in turn lights up your ESP BAS light.

Faulty Wheel Speed Sensor

The wheel speed sensor is there to monitor the speed of your vehicle’s four different wheels. All of your vehicle’s wheels are supposed to spin at the same rate but it can happen that each of them are spinning at different rates which will cause your ESP BAS light to turn on if the your car’s ESP and BAS systems cannot fix them or make all of the wheels spin at the same rate.

Faulty Steering Angle Sensor

The steering angle sensor works hand in hand with your steering wheel to helps you steer your car to the left and to the right. In some cases the steering angle sensor on your car can stop functioning properly if that happens your car’s ESP BAS light will turn on.

Frequently Asked Questions (FAQs)

How often should you reset the ESP BAS Light?

The ESP BAS light indicates that your car is facing some technical problems and resetting is only advised if you know what you are doing.

How long does it take to reset the ESP BAS Light?

The ESP BAS light can be reset by using the step-by-step guide given above in a matter of a few minutes.

What to do after resetting the ESP BAS Light?

After resetting the ESP BAS light you can continue driving as usual if you don’t experience any problems.


The ESP BAS light is an extremely important indicator. It tells us if your car is facing technical problems and need a diagnosis. We hope you were able to fix or reset your ESP BAS light after reading this article. If you were unable to turn off or reset your ESP BAS at the first go then we advise you to try again by following the step-by-step guide given above.

Related Posts:

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *