How to reset maintenance light on Toyota Tundra – detailed step-by-step guide

Here is the main information for all who have problems with the oil change indicator light in Toyota Tundra. You always have two ways – schedule the visit to your car service or resolve the issue by yourself.

Toyota Tundra maintenance

To ensure your driving safety and keep your pickup truck in peak condition, you must follow the maintenance required schedule developed by Toyota dealers.

General services that you should carry out: replacement of brake pads, changes of filters, tire rotations, changes of engine oil, and also other main requirements.

Keeping your Tundra maintenance plan is the best way to prevent expensive repairs, increase your vehicle’s value for resale, and your Toyota Tundra will run smoothly.

Toyota Tundra maintenance reset

Every 5000 miles of your Toyota Tundra running you need to perform an oil change and illuminate the “Maintenance Required” light reminder about this procedure. It isn’t an emergent signal so you have time to schedule an oil change. This light displays in automatic mode after 5000 miles since the last reset.

When you change the oil for your Tundra truck at the local dealership center, the staff of the dealership will reset the Tundra maintenance light after all services.

But you can change the oil by yourself, then you should perform a maintenance light reset procedure also. To reset the oil indicator light for your Tundra, you don’t require any tools or supplies. After this measure, Tundra maintenance light will turn off and 5000 – the mile countdown will restart.

Maintenance required Light reset for Toyota Tundra 2018

Maintenance reset guide for the Toyota Tundra.

1. You turn the ignition on your vehicle using a double push Start button without starting the engine. Also, don’t step on the brake pedal.
2. Choose “Vehicle Settings” on the multi-information display by navigation buttons on the steering wheel.
3. Find “Maintenance Reset” and push on the center button. Press “Yes” to accept the maintenance light reset.

Maintenance Required Light reset for Toyota Tundra 2007–2017

5 points of vehicle settings instruction of maintenance required light below.

1. Do not start the Toyota Tundra engine, only turn the “On” position on the ignition or press the “Start” button.
2. Choose “Trip A” by display the change button or press the “Trip” button.
3. Turn your Tundra off.
4. You must hold the “Trip” button and switch the ignition to the “On” position.
5. You can release “Trip” after you see all zeros at your trip meter at the odometer instrument cluster.

Maintenance required Light reset for Toyota Tundra 2000–2006

Similar instruction as for 2007 – 2017 models, but with the only difference of maintenance required in the second point.

1. Do not start the Toyota engine, only turn the “On” position on the ignition or press the “Start” button without stepping on the brake pedal.
2. Use the “Trip” button and switch the display to the odometer mileage reading.
3. Turn your Tundra all the way off.
4. You must hold the “Trip” button and switch the ignition to the “On” position.
5. You can release the “Trip” button after you see all zeros on your trip meter.

Maintenance reset resume

When all stages of Toyota Tundra maintenance instructions for oil change indicator light reset are completed, “Maintenance Required” light would be turned off. But sometimes you may have some problems with the oil light.

Then it is time to research your Toyota Tundra maintenance manual, or you can get instructions and recommendations from your local Toyota dealership.

Read also: P0102 Chevy Silverado. Causes and remedies